Feed your wire in. The insulation slices off. Bare copper comes out the other side. Scrap yards pay more for bare copper than insulated, and most buyers say the machine pays for itself on the first run.
Make Wire Stripping Faster and More Efficient
30 Day Money Back Guarantee | 1-Year Warranty
A Closer Look at the Customer Experience
We restock weekly, and current inventory moves quickly. If it’s showing In Stock, we recommend ordering today — once this batch sells out, we can’t reserve units and the next shipment goes out the following week.
Stop Selling Your Copper at the Insulated Rate
That bucket of wire in your shop is worth more than you're getting for it. Scrap yards pay more for bare copper. Strip it first and every pound goes up in value.
Feed the wire in. The blade slices the jacket. The motor pulls it through. Bare copper comes out the other side. Most buyers make the machine back on their first run.
A Week of Stripping, Done in a Day
You used to spend whole weekends with a razor knife. Sore hands. Cut fingers. Barely a dent in the pile. Now you set the gauge, sit down and feed it in.
IronRidge
Hand
Built for Thousands of Pounds
Customers have run over 2,500 ft of wire through it and say the blades are still going strong after 2,500 lbs.
A metal housing, a strong gear motor, and a clear acrylic cover so you can see the strip depth as you work. Backed by a 1-year warranty and our 30-day money-back guarantee.
Not a $50 Drill Attachment
Customers tried the cheap manual and drill-powered strippers first. They returned them.
This one has its own motor, seven channels and an adjustable blade. You get clean strips across almost every size you'll find in a scrap pile.
Dialed In on Day One
Every order comes with a gauge quick-start chart that shows which channel and blade depth to use for each wire size. Plus a setup and blade-change video.
A few tips from customers:
Run each wire through once. A second pass can nick the copper.
Run one size at a time.
On small stranded wire, wear gloves and go slightly shallower.
Try It on Your Next Scrap Run
If it doesn't pay you back, send it back within 30 days for a full refund. Every machine is also covered by a 1-year warranty
CLAIM OFFER
The Gift That Pays Him Back
Customers are buying these for husbands, brothers and the electricians in their lives.
One wrote: "Ladies, buy this for your man."
He'll use it every weekend. And it makes him money every time.
Frequently Asked Questions
Find answers to common questions about our products, shipping, returns, and more.
There's a short learning curve. Use the included gauge chart to pick the right channel and blade depth for each wire size, and watch the setup video. Most customers are stripping cleanly within the first few minutes.
Most customers say it's quiet. One runs it outside a sleeping baby's window. Expect a
steady motor hum during long sessions.
The blade is set too deep, or the wire is thinner than #10. Raise the blade slightly and run a test piece. Don't run the same wire twice.
Keep your hands clear of the feed rollers and wear the included gloves, especially on small stranded wire, which can leave sharp ends. Use the emergency stop if wire jams.
One at a time works best. With two different sizes, the smaller one won't strip all the way.
Customers who tried the $50 manual and drill-powered versions returned them. This one has its own motor and handles wire from 0.06" to 0.98".
Follow the blade-change video included with your order. Keep the spare blade that comes free with your machine on hand.
1 year, plus our 30-day money-back guarantee.



